Simple dual upstream gateways in CentOS, Take II

Recently had to setup a few servers that needed dual upstream gateways, and used an ancient blog post I wrote 11 years ago (!) to get it all working. This time around I hit a gotcha that I hadn't noted in that post, and used a simpler method to define the rules, so this is an updated version of setting up super-simple policy-based routing on CentOS.

Situation: you have two upstream gateways (gw1 and gw2) on separate interfaces and subnets on your linux server. Your default route is via gw1 (so all outward traffic, and most incoming traffic goes via that), but you want to be able to use gw2 as an alternative ingress pathway, so that packets that have come in on gw2 go back out that interface.

(Everything below done as root, so sudo -i first if you need to.)

1) First, define a few variables to make things easier to modify/understand:

# The device/interface on the `gw2` subnet
GW2_DEV=eth1
# The ip address of our `gw2` router
GW2_ROUTER_ADDR=172.16.2.254
# Our local ip address on the `gw2` subnet i.e. $GW2_DEV's address
GW2_LOCAL_ADDR=172.16.2.10

2) The gotcha I hit was that 'strict reverse-path filtering' in the kernel will drop all asymmetrically routed entirely, which will kill our response traffic. So the first thing to do is make sure that is either turned off or set to 'loose' instead of 'strict':

# Check the rp_filter setting for $GW2_DEV
# A value of '0' means rp_filtering is off, '1' means 'strict', and '2' means 'loose'
$ cat /proc/sys/net/ipv4/conf/$GW2_DEV/rp_filter
1
# For our purposes values of either '0' or '2' will work. '2' is slightly
# more conservative, so we'll go with that.
echo 2 > /proc/sys/net/ipv4/conf/$GW2_DEV/rp_filter
$ cat /proc/sys/net/ipv4/conf/$GW2_DEV/rp_filter
2

3) Define an extra routing table called gw2 e.g.

$ cat /etc/iproute2/rt_tables
#
# reserved values
#
255     local
254     main
253     default
0       unspec
#
# local tables
#
102     gw2
#

4) Add a default route via gw2 (here 172.16.2.254) to the gw2 routing table:

$ echo "default table gw2 via $GW2_ROUTER_ADDR" > /etc/sysconfig/network-scripts/route-${GW2_DEV}
$ cat /etc/sysconfig/network-scripts/route-${GW2_DEV}
default table gw2 via 172.16.2.254

5) Add an iproute 'rule' saying that packets that come in on our $GW2_LOCAL_ADDR should use routing table gw2:

$ echo "from $GW2_LOCAL_ADDR table gw2" > /etc/sysconfig/network-scripts/rule-${GW2_DEV}
$ cat /etc/sysconfig/network-scripts/rule-${GW2_DEV}
from 172.16.2.10 table gw2

6) Take $GW2_DEV down and back up again, and test:

$ ifdown $GW2_DEV
$ ifup $GW2_DEV

For more, see:

blog comments powered by Disqus